Appendix C: OPTIONAL SAMPLING COMPONENTS
Optional sampling components include:
Before sampling with the P100:
• Compressed Air/Gas Sampling Kit (C.1)
• Horizontal Flow Inlet (C.2)
• Remote “Probe” Sampling Kit (C.3)
• Remote Exhaust Kit (C.4)
C.1 Compressed Air/Gas Sampling Kit
The P100 may be used for Compressed Air/Gas system testing. This can be performed with the
following components, supplied with the kit:
1 EMTEK MICRO HPD (High pressure diffuser)
A – Exhaust Filters
B – Sanitary Inlet Adapter (100 or 28.3 LPM) (from compressed air/gas drop)
C – Outlet Barb (100 or 28.3 LPM) (to P100)
D – Micro HPD Body
2 Sanitary Clamp/Seal
3 0.500” ID Tubing (30”, 0.75m)
4 P100 Inlet Cover Adapter (with O-ring)
NOTE: For detailed use of the MICRO HPD, see EMTEK MICRO HPD Procedure, for compressed
air/gas sampling with the P100. General instructions are as follows:
To Next Page
Loading...