Section 8 Network Operation of the P100
The Ethernet port is provided to allow for the Calibration of the unit via an external Calibration Software Program. Contact
EMTEK, LLC for more information regarding the Calibration Software Program.
The P100 is equipped with an Ethernet 10Base-T/100Base-T Port that will allow for an optional PC based software program
to view or extract the Sample Run Data (Run Data), and/or operate the P100 units connected to the Ethernet. The Sample
Run Data can be downloaded or viewed, but cannot be modified while within the units memory. Contact EMTEK, LLC for
more information regarding the PC based remote operation software program.
Beginning with Firmware Version 1.092, the P100 also includes Mapped Modbus Registers (16-bit) to allow communication,
and unit operation, through customers Facility Monitoring Systems (FMS). EMTEK does not write the drivers required to
communicate with FMS software, but can provide the Register Maps if requested. Please contact EMTEK for additional
information on this capability.
To Next Page
Loading...
Need help?
General