How to resolve Internal ERROR "Encoder Sensor Failure" on ENCAD CADJET?
If your ENCAD printer shows an Internal ERROR "Encoder Sensor Failure", here are some possible solutions: * The encoder sensor cable might be unseated. Reseat the encoder sensor cable. * The encoder sensor could be bad. Replace the encoder sensor.
What to do if Keypad Locked-Up or Not Functioning Properly on ENCAD CADJET?
If the keypad on your ENCAD printer is locked up or not functioning properly, consider the following: * There may be a firmware problem. Reset the printer or refresh/upgrade the firmware. * The keypad assembly might be damaged. Replace the keypad assembly. * There could be a faulty connection between the MPCB and the keypad. Reseat or replace the connector.
Why ENCAD CADJET Fan Does Not Power Up?
If the fan on your ENCAD printer does not power up, check the following: * Ensure the MPCB has 24 VDC at J3 to the fan. Reseat the connection at the MPCB to the fan or replace the fan. * If power is not being applied to the fan, reload the firmware or replace the MPCB.
General| Technology | Inkjet |
|---|---|
| Print Technology | Thermal Inkjet |
| Ink Colors | Cyan, Magenta, Yellow, Black |
| Type | Large Format |
| Maximum Print Width | 36 inches |
| Media Types | Film |
| Interface | Parallel |
Outlines the printer's warranty period, coverage, and conditions that void the warranty.
Covers ESD precautions, warnings, related publications, and technical support contacts.
Describes the MPCB, microprocessor, memory, controllers, and interface circuits.
Covers slide shaft, head height, color, deadband, paper axis alignments, and diagnostics menu.
Introduces troubleshooting, covers no power, initialization, and media movement problems.
Addresses banding, paper skewing, image issues, and internal error codes.
Covers removal/installation of Keypad, Display, Power Supply, MPCB, and Motors.
Details procedures for servicing the Carriage Assembly, belt, PCB, sensors, and bushings.
To Next Page