3-2 Maintenance
CadJet 3D Service Manual
Cleaning Procedures
Always turn the printer OFF, remove the power cord and
the interface cable before cleaning the printer. An electri-
cal shock hazard may be present if these procedures are
not followed.
External Cleaning
Do not use abrasive cleansers of any sort on the surfaces
of the printer. Damage to the surface may result.
The exterior surfaces of the printer may be cleaned with a soft cloth
which has been dampened. For more persistent stains, a small amount
of liquid detergent may be used. Cleaning intervals are determined by
the environment in which the printer is used.
Slide Shaft Cleaning
Use only isopropyl alcohol on the slide shaft of the printer.
Damage to the stainless steel slide shaft may result if
cleaned with water and not completely dried off.
To Next Page
Loading...