4
4-1
TROUBLE-
SHOOTING
Troubleshooting
No Power
• printer not ON depress power
switch
• faulty power replace power cord
cord
• AC input not replace AC entry
present at power module
supply
Introduction
Chapter 4, Troubleshooting consists of a table that is intended to aide
the technician in troubleshooting the CadJet 3D printers. This table
addresses symptoms with their possible causes and solutions.
Basic troubleshooting skills will be required to perform the symptom
identification, troubleshooting, fault isolation, and repair of the printer
when using this table.
Ensure that all applicable software diagnostic tests have been properly
executed, all visual indications (including LED status) have been
observed, and all applicable pushbuttons have been depressed to obtain
a complete list of symptoms to be applied to the table below.
Use the table in conjunction with Chapter 3, Maintenance, whenever
the table prompts you for additional information. This information
may be in the form of an illustration, additional data, or a procedure
that needs to be performed.
Table 4-1. Troubleshooting Table.
Symptoms Possible cause Solution
To Next Page
Loading...