Enclustra Mars ZX3 User Manual

3.10 FPGA and QSPI Flash Programming using Xilinx Impact
For Zynq-7000 devices, Xilinx Impact requires JTAG boot mode to be selected in order to download the
bitstream or program the QSPI flash.
As this operation on the Mars ZX3 SoC module requires hardware changes (please refer to Section 3.3.1), it
is recommended to use Xilinx SDK or Vivado for FPGA or QSPI flash programming.
3.11 Enclustra Module Configuration Tool
In combination with an Enclustra base board, the QSPI flash can be programmed using the Enclustra Module
Configuration Tool (MCT) [16].
Please note that the Xilinx Zynq devices do not support slave serial configuration, therefore only flash pro-
gramming is supported by the Enclustra MCT for the Mars ZX3 SoC module.
D-0000-424-004 38 / 48 Version 05, 21.08.2018

Enclustra Mars ZX3 Specifications

General

Brand	Enclustra
Model	Mars ZX3
Category	Control Unit
Language	English