1 Overview
1.1 General
1.1.1 Introduction
The Mercury+ XU6 SoC module combines the Xilinx Zynq® UltraScale+ MPSoC (Multiprocessor System-
on-Chip) device with USB 3.0, PCIe® Gen3 ×4, PCIe® Gen2 ×4, two USB 2.0 PHYs, one Gigabit Ethernet
PHY, DDR4 SDRAM with Error Correction Code (ECC), eMMC flash, multi-gigabit transceivers, high-speed
LVDS I/O, and is available in industrial temperature range, forming a complete and powerful embedded
processing system.
The use of the Mercury+ XU6 SoC module, in contrast to building a custom MPSoC hardware, significantly
reduces development effort and redesign risk and improves time-to-market for the embedded system.
Together with Mercury+ base boards, the Mercury+ XU6 SoC module allows the user to quickly build a
system prototype and start with application development.
The Enclustra Build Environment [14] is available for the Mercury+ XU6 SoC module. This build system
allows the user to quickly set up and run Linux on any Enclustra SoC module. It allows the user to choose
the desired target and download all the required binaries, such as bitstream and FSBL (First Stage Boot
Loader). It downloads and compiles all required software, such as U-Boot, Linux, and BusyBox based root
file system.
1.1.2 Warranty
Please refer to the General Business Conditions, available on the Enclustra website [1].
Warning!
Please note that the warranty of an Enclustra module is voided if the FPGA fuses are blown. This
operation is done at own risk, as it is irreversible. Enclustra cannot test the module in case of a warranty
product return.
1.1.3 RoHS
The Mercury+ XU6 SoC module is designed and produced according to the Restriction of Hazardous Sub-
stances (RoHS) Directive (2011/65/EC).
1.1.4 Disposal and WEEE
The Mercury+ XU6 SoC module must be properly disposed of at the end of its life.
The Waste Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) is not applicable for the Mer-
cury+ XU6 SoC module.
1.1.5 Safety Recommendations and Warnings
Mercury+ modules are not designed to be “ready for operation” for the end-user. These can only be used
in combination with suitable base boards. Proper configuration of the hardware before usage is required.
Ensure that the power supply is disconnected from the board before inserting or removing the Mercury+
XU6 SoC module, connecting interfaces, or connecting jumpers.
D-0000-464-001 6 / 58 Version 02, 21.07.2021
To Next Page
Loading...
Need help?
General
