On-board clock generation is based on a 33.33 MHz crystal oscillator. In addition, two oscillators delivering
100 MHz and 27 MHz reference clocks for the MGT GTR lines, are equipped on the module.
The module’s internal supply voltages are generated from a single input supply of 5 - 15 V DC. Some of
these voltages are available on the Mercury module connectors to supply circuits on the base board.
Six LEDs are connected to the MPSoC pins for status signaling.
2.2 Module Configuration and Product Models
Table 1 describes the available standard module configurations. Custom configurations are available; please
contact Enclustra for further information.
Product Model MPSoC DDR4 (PS) DDR4 (PS) Temperature
SDRAM ECC Range
ME-XU6-2CG-1E-D10H
1
XCZU2CG-1SFVC784E 1 GB 7 0 to +85
◦
C
ME-XU6-2EG-1I-D13E XCZU2EG-1SFVC784I 8 GB 3 -40 to +85
◦
C
ME-XU6-3EG-2I-D11 XCZU3EG-2SFVC784I 2 GB 7 -40 to +85
◦
C
ME-XU6-4CG-1E-D12 XCZU4CG-1SFVC784E 4 GB 7 0 to +85
◦
C
ME-XU6-4EV-1I-D12 XCZU4EV-1SFVC784I 4 GB 7 -40 to +85
◦
C
ME-XU6-5EV-2I-D12E XCZU5EV-2SFVC784I 4 GB 3 -40 to +85
◦
C
Table 1: Standard Module Configurations
1
The product model indicates the module type and main features. Figure 2 describes the fields within the
product model.
1
This variant supports only half of the DDR4 bandwidth on the PS side (32-bit interface instead of 64-bit). Refer to Section 2.15 for
details.
D-0000-464-001 12 / 58 Version 02, 21.07.2021
To Next Page
Loading...
