The Enclustra Build Environment features a graphical user interface (GUI) and a command line interface (CLI)
that facilitates the automatic build flow.
The Enclustra Build Environment How-To Guide [15] describes in more detail how to use the EBE to customize
the provided software for the user application. The document provides information on the configuration
options for U-boot, Linux kernel and Buildroot, debugging possibilities for Linux applications, customization
of device trees and integration of existing or new kernel drivers.
1.4.3 Enclustra Heat Sink
For Mercury modules an Enclustra heat sink is available for purchase along with the product. Please refer
to section 2.11.6 for further information on the available cooling options.
1.4.4 Mercury+ PE1 Base Board
• 168-pin Hirose FX10 module connectors (PE1-200: 2 connectors; PE1-300/400: 3 connectors)
• System controller
• Power control
• System monitor (PE1-300/400)
• Current sense (PE1-300/400)
• Low-jitter clock generator (PE1-300/400)
• microSD card holder
• User EEPROM
• eMMC managed NAND flash (PE1-300/400)
• PCIe ×4 interface
• USB 3.0 device connector
• USB 2.0 host connector (PE1-200: 1 connector; PE1-300/400: 4 connectors)
• Micro USB 2.0 device (UART, SPI, I2C, JTAG) connector
• 2 × RJ45 Gigabit Ethernet connectors
• mPCIe/mSATA card holder (USB only) (PE1-300/400)
• SIM card holder (optional, PE1-300/400 only)
• SMA clock and data in/out (optional, PE1-300/400 only)
• 1 × FMC LPC connector (PE1-200)
• 1 × FMC HPC connector (PE1-300)
• 2 × FMC LPC connector (PE1-400)
• 2 × 40-pin Anios pin header
• 3 × 12-pin IO headers
• 5 to 15 V DC supply voltage
• USB bus power (with restrictions)
Please note that the available features depend on the equipped Mercury module type and on the selected
base board variant.
1.4.5 Mercury+ ST1 Base Board
• 168-pin Hirose FX10 module connectors (3 connectors)
• 2 × MIPI D-PHY connectors: CSI and CSI/DSI (requires FPGA support)
• Mini DisplayPort connector (requires FPGA support)
• HDMI connector (requires FPGA support)
• SFP+ connector
• Low-jitter clock generator
• USB 3.0 device connector
• USB 3.0 host connector
• FTDI USB 2.0 device controller with micro USB device connector (UART, SPI, I2C, JTAG)
• 2 × RJ45 Gigabit Ethernet connectors
• 1 × FMC HPC connector (note: not all pins are available)
• 2 × 40-pin Anios pin header
D-0000-464-001 9 / 58 Version 02, 21.07.2021
To Next Page
Loading...
