Endress+Hauser Cerabar M PMC41 - Process Connections PMP41 (with Metal Measuring Diaphragm)

Cerabar M
Endress+Hauser 41
Process connections PMP41
(with metal measuring
diaphragm)
Note!
• The installation heights in brackets apply to housings with a raised cover (for optional display). Installation
heights written in italics apply to devices with an aluminum housing.
Thread, inner diaphragm
P01-PMP41xxx-06-09-xx-xx-000
Process connections PMP41, material: AISI 316L
➀ Version 1M: thread ISO 228 G 1/2 A
➁ Version 1G: thread ANSI MNPT 1/2, bore 11.4 mm
➂ Version 1X: thread ANSI FNPT 1/2
➃ Version 1S: thread JIS B0202 G 1/2 (male)
➄ Version 1K: thread JIS B0203 R 1/2 (male), bore 11.4 mm
➅ Version 1T: thread DIN 13 M 20x1.5
Note!
The 1M, 1G, 1X, 1S, 1K and 1T versions listed above are available as threaded or welded versions. Using
feature 80 "Seal; Fill fluid" in the order code, select the version in conjunction with the seal and the filling oil.
→ See the following page also.
G½
½ NPT
ø6
ø3
ø11.4
½ NPT
3
20
151.5 (171.5)
151.5 (171.5)
165 (185)
17
25
ø8
160.5 (175.5)
160.5 (175.5)
174 (189)
G½
JIS B 0202-1982
R½
JIS B 0202-1982
ø5
ø11.4
ø3
3
20
151.5 (171.5)
151.5 (171.5)
25
17
ø8
M 20x1.5
ø6
ø3
5
20
151.5 (171.5)
17
ø8
160.5 (175.5)
160.5 (175.5)
160.5 (175.5)
➀
G½A
➁
MNPT ½
➂
FNPT ½
➃
G½
➄
R½
➅
M20x1.5
ø30
ø30
ø30
ø30
ø30
Threaded versions
Can be selected in conjunction with versions 1, H, P for
feature 80 "Seal; Fill fluid" in the order code
(→ see Page 70)
Welded versions
Can be selected in conjunction with versions A, C, D for
feature 80 "Seal; Fill fluid" in the order code
(→ see Page 70)
P01-PMP41xxx-06-09-xx-xx-004 P01-PMP41xxx-06-09-xx-xx-005
SW 32
SW 27
SW 25