Endress+Hauser Deltabar S PMD75 - Heat Insulation - FMD77; Wall- and Pipe-Mounting

Deltabar S
24 Endress+Hauser
Heat insulation – FMD77 The FMD77 must only be insulated up to a certain height. The maximum permitted insulation height is labelled
on the devices and applies to an insulation material with a heat conductivity
 0.04 W/(m x K) and to the maximum permitted ambient and process temperature ( see table below). The
data were determined under the most critical application "quiescent air".
P01-FMD77xxxx-11-xx-xx-xx-000
Maximum permitted insulation height
Wall- and pipe-mounting Endress+Hauser offers a mounting bracket for installing the device on pipes or walls.  ä 67 ff, feature 110,
"Additional options 2".
Note!
If a valve block is used, its dimensions should also be taken into consideration.
P01-xMD7xxxx-11-xx-xx-xx-008
Mounting bracket for wall and pipe-mounting
A bracket including mounting accessories for pipe mounting is included with the device.
1 Device mounting
λ 0.04≤
W
mK•
T
A
T
P
FMD77
Ambient temperature (T
A
)  70°C (158°F)
Process temperature (T
P
) max. 400°C (752°F), depending on the
diaphragm seal filling oil used ( see
page 59)
106
74
74
124
135
37.5
➀