Why is the output current less than 3.6 mA on my Endress+Hauser Radar?
If the output current is less than 3.6 mA on your Endress+Hauser Radar device: * Check the signal cable connection to ensure it is correct. * Replace the electronics, as the electronics might be defective.
Why CDI communication does not work for Endress+Hauser Radar?
If CDI communication does not work with your Endress+Hauser Radar, the COM port on the computer might be set incorrectly. Check the setting of the COM port on the computer and change it if necessary.
How to fix the wrong measured value on Endress+Hauser Levelflex FMP54?
A likely cause is a calibration error. To resolve this, check the Empty calibration parameter and adjust it if necessary. Also, check the Full calibration parameter and adjust it if needed. Finally, check the linearization and adjust it as necessary.
What to do if there is no change of the measured value when emptying/filling the tank in Endress+Hauser Measuring Instruments?
This issue may arise if an interference echo affects the measurement. To address it, perform mapping (interference echo suppression).
Why Endress+Hauser Levelflex FMP54 Measuring Instruments display a level when the tank is empty?
The device may display a level even when the tank is empty due to an incorrect probe length. To solve this, carry out a probe length correction. Another possible cause is interference echo. In this case, carry out mapping over the entire probe when the tank is empty.
Outlines necessary qualifications for personnel.
Specifies intended application and materials.
Details safety measures for working with the device.
Covers safe operation, conversions, and repairs.
Covers general requirements and suitable positions.
Details tensile and bending strength limits.
Discusses threaded connections and seals.
Details mounting instructions for cladded flanges.
Covers securing rope probes.
Details probe rod mounting for FMP54 with GPC.
Covers device mounting with thread and flange.
Details mounting for remote sensor versions.
Lists final checks after installation.
Details terminal assignment and cable specifications.
Provides details on cable types and specifications.
Details power supply requirements for different approvals.
Step-by-step guide for connecting the device.
Lists checks after connecting the device.
Guides on configuring blocks for operation.
Step-by-step guide for configuring level measurement.
Guide for configuring interface measurements.
Provides solutions for common device issues.
Guides on accessing remedial measures for diagnostic events.
Details parameters within the Setup menu.
Outlines diagnostic functions and messages.
General| Measuring Principle | TDR (Time Domain Reflectometry) |
|---|---|
| Measuring Range | Up to 30 m |
| Output | 4-20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Power Supply | 10.5 to 36 V DC (two-wire) |
| Housing Material | Aluminum, Stainless Steel |
| Process Connection | Thread, Flange |
| Approvals | ATEX, IECEx |
| Material | PTFE |
| Protection Class | IP66/IP67 |
To Next Page