Endress+Hauser Liquiphant FTL62 - Product Design Overview; Incoming Acceptance and Product Identification; Incoming Acceptance Checklist

Incoming acceptance and product identification Liquiphant FTL62 HART
10 Endress+Hauser
3.1 Product design
1
3
5
2
4
A0042276
 1 Product design
1 Housing with electronic insert and cover
2 Temperature spacer, pressure-tight feedthrough (second line of defense), optional
3 Process connection flange
4 Pipe extension probe with tuning fork
5 Short pipe probe with tuning fork
Plastic-coated or enamel-coated: flange, pipe extension and tuning fork
No enamel coating: temperature spacer, pressure-tight feedthrough
4 Incoming acceptance and product
identification
4.1 Incoming acceptance
Check the following during incoming acceptance:
 Are the order codes on the delivery note and the product sticker identical?
 Are the goods undamaged?
 Do the data on the nameplate match the ordering information on the delivery note?
 If required (see nameplate): are the Safety Instructions e.g. XA provided?
If one of these conditions is not met, please contact the manufacturer's sales office.