EasyManua.ls Logo

Endress+Hauser Liquistation CSF48 - Page 21

Endress+Hauser Liquistation CSF48
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Liquistation CSF48 General settings
21
Webserver Options
•Off
•On
Factory setting
On
You can switch the internal web server on and off at this
point.
Off:
It is then not possible to access the device via the web
browser.
DHCP Options
•Off
•On
Factory setting
Off
The Dynamic Host Configuration Protocol (DHCP) makes
it possible to assign the network configuration to clients
via a server. With DHCP, it is possible to automatically
integrate the device into an existing network without
the need for manual configuration. Normally, the client
need only be configured for automatic retrieval of the IP
addresses. During startup, the IP address, the netmask
and the gateway are retrieved from a DHCP server.
IP-Address xxx.xxx.xxx.xxx
Factory setting
192.168.1.212
An IP address is an address in computer networks which
are based on the Internet protocol (IP).
Netmask xxx.xxx.xxx.xxx
Factory setting
255.255.255.0
On the basis of the IP address of a device, the netmask
specifies which IP addresses this device searches for in
its own network and which addresses it could access in
other networks via a router. It therefore divides the IP
address into a network part (network prefix) and a
device part. The network part must be identical for all
devices in the individual network, and the device part
must be different for every device within the network.
Gateway x.x.x.x
Factory setting
0.0.0.0
A gateway (protocol converter) enables communication
between networks that are based on completely
different protocols.
MAC-Address Read only The MAC address (Media Access Control address) is the
hardware address of every individual network adapter
which is used to uniquely identify the device in a
computer network.
Modbus TCP port Read only The Transmission Control Protocol (TCP) is an
arrangement (protocol) as to how data should be
exchanged between computers.
A port is a part of an address which assigns data
segments to a network protocol.
Webserver TCP port Read only
Path: Menu/Setup/General settings/Extended setup/Ethernet
Function Options Info

Table of Contents

Other manuals for Endress+Hauser Liquistation CSF48

Related product manuals