Endress+Hauser Proline Promass F 500 - Configuring the Totalizer

Proline Promass F 500 Modbus RS485 Commissioning
Endress+Hauser 125
Parameter overview with brief description
Parameter Description Selection Factory setting
Installation direction Set sign of flow direction to match the
direction of the arrow on the sensor.
• Flow in arrow direction
• Flow against arrow direction
Flow in arrow direction
Zero point adjustment
All measuring devices are calibrated in accordance with state-of-the-art technology.
Calibration takes place under reference conditions →  190. Therefore, a zero point
adjustment in the field is generally not required.
Experience shows that zero point adjustment is advisable only in special cases:
• To achieve maximum measuring accuracy even with low flow rates
• Under extreme process or operating conditions (e.g. very high process temperatures or
very high-viscosity fluids).
Navigation
"Setup" menu → Advanced setup → Sensor adjustment → Zero point adjustment
‣
Zero point adjustment
Zero point adjustment control
→  125
Progress
→  125
Parameter overview with brief description
Parameter Description Selection / User interface Factory setting
Zero point adjustment control Start zero point adjustment. • Cancel
• Busy
• Zero point adjust failure
• Start
Cancel
Progress Shows the progress of the process. 0 to 100 % –
10.4.3 Configuring the totalizer
In the "Totalizer 1 to n" submenu the individual totalizer can be configured.
Navigation
"Setup" menu → Advanced setup → Totalizer 1 to n
‣
Totalizer 1 to n
Assign process variable
→  126
Unit totalizer 1 to n
→  126
Totalizer operation mode
→  126
Failure mode
→  126