Endress+Hauser Proline Promass F 500 - Ensuring the Degree of Protection

Proline Promass F 500 Modbus RS485 Electrical connection
Endress+Hauser 61
Proline 500 – digital transmitter
Power
I/O 2
I/O 3
I/O 3
Off
On
1 2
3
4
4.
3.
-
+
-
ESC
2.
Power
open
press
open
press
ESC
E+
-
I/O 4
Power
I/O 2
I/O 3
1.
A0029675
1. Open the housing cover.
2. Remove the display module.
3. Fold open the terminal cover.
4. Switch DIP switch No. 3 to On.
Proline 500 transmitter
‣
On
Off
2
1
4
3
A0029632
Switch DIP switch No. 3 to On.
7.7 Ensuring the degree of protection
The measuring device fulfills all the requirements for the IP66/67 degree of protection,
Type 4X enclosure.
To guarantee IP66/67 degree of protection, Type 4X enclosure, carry out the following
steps after the electrical connection:
1. Check that the housing seals are clean and fitted correctly.
2. Dry, clean or replace the seals if necessary.
3. Tighten all housing screws and screw covers.
4. Firmly tighten the cable glands.