Endress+Hauser Proline Promass F 500 - 10.3.2 Setting the System Units

Proline Promass F 500 Modbus RS485 Commissioning
Endress+Hauser 95
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters such as
letters, numbers or special
characters (e.g. @, %, /).
Promass
10.3.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Depending on the device version, not all submenus and parameters are available in
every device. The selection can vary depending on the order code.
Navigation
"Setup" menu → System units
‣
System units
Mass flow unit
→  95
Mass unit
→  95
Volume flow unit
→  96
Volume unit
→  96
Corrected volume flow unit
→  96
Corrected volume unit
→  96
Density unit
→  96
Reference density unit
→  96
Temperature unit
→  96
Pressure unit
→  96
Parameter overview with brief description
Parameter Description Selection Factory setting
Mass flow unit Select mass flow unit.
Result
The selected unit applies for:
• Output
• Low flow cut off
• Simulation process variable
Unit choose list Country-specific:
• kg/h
• lb/min
Mass unit Select mass unit. Unit choose list Country-specific:
• kg
• lb