Endress+Hauser Proline Promass F 500 - Certificates and Approvals

Technical data Proline Promass F 500 Modbus RS485
206 Endress+Hauser
Data logging
Manual
If the Extended HistoROM application package (order option) is enabled:
• Record up to 1 000 measured values via 1 to 4 channels
• User configurable recording interval
• Record up to 250 measured values via each of the 4 memory channels
• Export the measured value log via a variety of interfaces and operating tools e.g.
FieldCare, DeviceCare or Web server
• Use the recorded measured value data in the integrated device simulation function in the
Diagnostics submenu (→  168).
Service logbook
Manual
• Create up to 20 user-specific events with a date and customized text in a separate
logbook for documentation of the measuring point
• Use for calibration or service operations, for example, or for maintenance or revision
work that has been performed
16.12 Certificates and approvals
CE mark The measuring system is in conformity with the statutory requirements of the applicable
EU Directives. These are listed in the corresponding EU Declaration of Conformity along
with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the CE mark.
C-Tick symbol The measuring system meets the EMC requirements of the "Australian Communications
and Media Authority (ACMA)".
Ex approval The devices are certified for use in hazardous areas and the relevant safety instructions are
provided in the separate "Safety Instructions" (XA) document. Reference is made to this
document on the nameplate.
Sanitary compatibility • 3-A approval
• EHEDG-tested
Modbus RS485 certification The measuring device meets all the requirements of the MODBUS/TCP conformity test and
has the "MODBUS/TCP Conformance Test Policy, Version 2.0". The measuring device has
successfully passed all the test procedures carried out.
Pressure Equipment
Directive
• With the identification PED/G1/x (x = category) on the sensor nameplate, Endress
+Hauser confirms conformity with the "Essential Safety Requirements" specified in
Appendix I of the Pressure Equipment Directive 2014/68/EC.
• Devices not bearing this marking (PED) are designed and manufactured according to
good engineering practice. They meet the requirements of Art. 4, Par. 3 of the Pressure
Equipment Directive 2014/68/EU. The range of application is indicated in tables 6 to 9
in Annex II of the Pressure Equipment Directive 2014/68/EC.
Radio approval Europe:
RED 2014/53/EU