Endress+Hauser Proline Prosonic Flow 93T Portable - Page 83

Proline Prosonic Flow 93T Portable Description of Device Functions
Endress+Hauser 83
Function group MULTIPLEX
Functional description
USER INTERFACE INFORMATION LINE MULTIPLEX
ASSIGN
(2620)
Use this function to define a second reading to be displayed in the main line alternately
(every 10 seconds) with the reading defined in the function ASSIGN (2600).
Options
OFF
VOLUME FLOW (CH1)
VOLUME FLOW IN % (CH1)
SOUND VELOCITY (CH1)
SIGNAL STRENGTH (CH1)
FLOW VELOCITY (CH1)
VOLUME FLOW BARGRAPH IN % (CH1)
SIGNAL BARGRAPH IN % (CH1)
ACTUAL CURRENT 1
TOTALIZER (1 to 3)
OPERATING/SYSTEM CONDITIONS
FLOW DIRECTION
ACCUMULATOR CHARGE
ACTUAL CURRENT INPUT
VOLUME FLOW DEVICE 2
Factory setting
OFF
!
Note!
Multiplex mode is suspended as soon as a fault / notice message is generated. The
message in question appears on the display.
• Fault message (identified by a lightning icon):
– If ON was selected in the function ACKNOWLEDGE FAULTS (8004), multiplex
mode is resumed as soon as the fault has been acknowledged and is no longer
active.
– If OFF was selected in the function ACKNOWLEDGE FAULTS (8004), multiplex
mode is resumed as soon as the fault is no longer active.
• Notice message (identified by an exclamation mark):
– Multiplex mode is resumed as soon as the notice message is no longer active.
If a channel is not visible, it does not appear in the options. Channels can be displayed
or hidden by means of the function MEASUREMENT (6880).
100% VALUE
(2621)
!
Note!
This function is not available unless VOLUME FLOW IN % was selected in the ASSIGN
function (2620).
• VOLUME FLOW IN % (CH1)
• VOLUME FLOW BARGRAPH IN % (CH1)
• SIGNAL BARGRAPH IN % (CH1)
Use this function to define the flow value to be shown on the display as the 100%
value.
User input
5-digit floating-point number
Factory setting
Depends on nominal diameter and country, [value] / [dm
3
to m
3
or US-gal to US-Mgal]
Corresponds to the factory setting for the full scale value ( ä 118).