THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION PROPRIETARY TO ENERGATE INC. NO PART OF ITS CONTENTS MAY BE DISCLOSED OR CONVEYED TO,
USED BY, OR COPIED TO A THIRD PARTY WITHOUT PRIOR WRITTEN CONSENT BY ENERGATE INC. PRINTED COPIES WILL BE CONSIDERED UNCONTROLLED.
AW000873-G 19
3.6 Placing the Foundation Thermostat on the Mounting Bracket
Push the bottom end of Foundation onto the mounting bracket until it snaps snugly into place before pushing
the top end on.
3.7 Removing the Foundation Thermostat from the Mounting Bracket
1. Use a large flathead screwdriver or large coin to lift up the snap-fit tab located on top of the mounting
bracket. Note: if the screwdriver is too small, the tab and/or thermostat housing can be damaged.
2. Lift the tab until Foundation is free to pull out.
3. Pull the top end of Foundation away from the mounting bracket until it is free of the snap-fit tab. Then lift
Foundation free of the mounting bracket.
Note: Be careful not to unplug any wiring that is still connected on the back.
To Next Page
Loading...
