Energate FZ100C - 11 Provisioning the Thermostat and Optional Equipment; Provisioning Thermostat Communication with a Zigbee Gateway

THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION PROPRIETARY TO ENERGATE INC. NO PART OF ITS CONTENTS MAY BE DISCLOSED OR CONVEYED TO,
USED BY, OR COPIED TO A THIRD PARTY WITHOUT PRIOR WRITTEN CONSENT BY ENERGATE INC. PRINTED COPIES WILL BE CONSIDERED UNCONTROLLED.
AW000873-G 54
11 Provisioning the Thermostat and Optional Equipment
11.1 Provisioning Thermostat Communication with a ZigBee Gateway
The ZigBee provisioning process allows the thermostat to communicate with a ZigBee gateway device that provides it
with information about utility events and consumption.
 Energate ZIP Connect is an IP-ZigBee gateway that allows the ZigBee thermostat to communicate via the
Internet. If the ZIP Connect is not already installed, in the Options and Accessories section, see 9.5 ZIP Connect.
 Thermostats can also communicate with a ZigBee-certified electricity meter. Refer to the documentation
provided by the utility for more information.
In many cases, the gateway for the home is provisioned for you. If it is not provisioned, you must provision the gateway
before you can configure the thermostat to communicate with it.
For troubleshooting the provisioning process, see 12.2 Troubleshoot Provisioning a Gateway.
11.1.1 Provision the Gateway Using the Load Management System (LMS)
This procedure describes how to provision a gateway device using Load Management System (LMS), a component of
Energate’s Consumer Connected Demand Response (CCDR).
If your utility uses a different tool, refer to the provisioning information provided by the utility.
1. Obtain one of the following:
 For ZIP Connect: The MAC Address of the device, which is printed on the box label and the ZIP Connect itself (as
“ZB MAC”).
 Foundation with Wi-Fi module: The MAC Address of the device, which is printed at the back of the Foundation
thermostat ( as MAC)
 For a ZigBee-certified electricity meter: The serial number of the meter.
2. Log in to LMS. If you are using a Foundation with a Wi-Fi module as a gateway, go to the Edit End Device page for
the Foundation and ensure that the “Wi-Fi Module” box is checked.
3.
4. Go to the Homes menu, click Manage Homes.
5. To search for the appropriate home configuration, enter information in one or more fields, and then click Submit.
For example, enter the account number.