EnGenius M36 - Repeater Mode Configuration Example

41
8NetworkConfigurationExample
ThischapterdescribestheroleoftheM36withthreedifferentmodes.TheAccessPointmode’s
defaultconfigurationisacentralunitofthewirelessnetworkorasarootdeviceofthewired
environment.RepeatermodeandMeshnetworkmodeneedfutureconfiguration.

8.1AccessPoint



AccessPoint
Step1 Logintotheweb‐based configurationinterfacewithdefa ultIP192.168.1.1
Step2 Selectyourcountryorregion’ sregulation.
Step3 Select802.11bor802.11gasyourwirelessmode.
Step4 Usesitesurveytoscanchannelsthathavebeenusedinnearbyarea.
Step5 Selectchannelwithlessinterferences.
Step6
SpecifytheSSIDforyourbroadcastSSIDandyoucanalsoconfiguremultipleSSIDat
thesametime.
Step7 VerifyVLANidentifiertoseparateservicesamongclients
Step8 Setuptheauthen ticationsettings.
Step9 PressApplytosaveallchanges.
Note:Formoreadvancedsettings,pleaserefertothepreviouschapters.

WirelessClient
Step1 Selectwireless modeyouwouldliketoassociatewith.
Step2
UsesitesurveytoscannearbyAccessPointandselectthecertainAPyouwouldlike
toconnectwithorenterSSIDmanually.