EnGenius M5000 - 8.4 Management → Backup;Restore Settings

59
8.3 Management → SNMP Settings
Click on the SNMP Settings link under the Management menu. This is a networking management
protocol used to monitor network-attached devices. SNMP allows messages (called protocol data
units) to be sent to various parts of a network. Upon receiving these messages, SNMP-compatible
devices (called agents) return data stored in their Management Information Bases.
SNMP Enable/Disable
Select the Radio button to Enable or Disable SNMP function.
Contact
Specify the contact details of the device.
Location
Specify the location of the device.
Community Name
Specify the password for access the SNMP community for read only access.
Community Name
Specify the password for access the SNMP community for read and write access.
Trap Destination IP
Address
Specify the IP address that will receive the SNMP trap.
Trap Destination
Community Name
Specify the password of the SNMP trap community.
Apply / Cancel
Press Apply to apply the changes or Cancel to return previous settings.