Envipco FLEX Series - Safety Labels

1
-
4
Chapter 1
Introductio
n
&
Safety
Warning!
Use extreme caution when operating a compactor with the doors
open. Keep your body and loose clothing well away from moving
parts. Make sure that no one else is near the machine during this
process.
Warning!
Do not allow water to come in contact with the electrical components.
Warning!
Use gloves and eye protection when opening and emptying a glass
machine. Glass dust can cause eye injury.
1.5. Safety labels
This section provides the details of all of the warning labels that are on the FLEX .
1.5.1. Laser safety
The US Food and Drug Administration requires the inclusion of laser safety information and
labels, pursuant to 21 CFR , Chapter 1, Subchapter J, Laser Product Performance Standard, Section
1040.10 (h). There is no possibility of exposure to laser radiation during machine operation.
Therefore, the FLEX is a CDRH Class 1 device. The label shown in Figure 1-1 shows that the FLEX
meets Class 1 criteria.
FIGURE 1-1 Laser Compliance Label
When performing the scanner maintenance tests, it is possible to be exposed to HeNe (633 nm)
laser radiation levels up to Class IIIa. This maintenance test is only performed by Envipco service
technicians. The label in Figure 1-2 gives the appropriate warning. Figure 1-3 shows the location of
the laser danger label.
PRODUCT COMPLIES WITH
U.S. DHHS STANDARD 21 CFR
CHAPTER I SUBCHAPTER J
CLASS I LASER PRODUCT
PN 300406