Envipco FLEX Series - Mechanical Safety; Compactor Motor Disconnect Label; Moving Parts Warning Label

1
-
8
Chapter 1
Introductio
n
&
Safety
The FLEX contains high voltage components in the AC Motor Control Box. Therefore, it has a label
warning of its danger. Figure 1-5 shows the warning. See Figure 1-3 for the exact location of this
label.
Warning!
Always turn the Compactor Motor Disconnect Switch to the OFF
position before performing service on the FLEX .
FIGURE 1-5. Compactor Motor Disconnect Label
1.5.3. Mechanical Safety
FLEX ’s moving parts can cause injury if they are operating while the doors are open. The following
warnings are meant to prevent injuries. Figure 1-6 shows the moving parts warning label. Figure 1-
7 shows its location on the inside of the lower cabinet door.
FIGURE 1-6. Moving Parts Warning Label