Envipco FLEX Series - RVM Software; Introduction; Shop Mode; Service Mode

4
-
1
Chapter 4
RVM Software
4.1. Introduction
The flex series introduces new software and electronics hardware to Envipco’s RVMs. There are three
software modes on the flex: Customer/Acceptance Mode, Shop Mode, and Service Mode.
•
••
• Customer/Acceptance Mode - This refers to the software that runs and
displays information while the cabinet doors are closed and the machine is
ready to accept containers or while the machine processes containers. In this
mode, the screen displays instructions to the user and may show videos.
•
••
• Shop Mode - Shop Mode can be configured to start automatically when the
cabinet door is opened. It can also be configured to require a PIN. Once in this
mode, store personnel may review machine information, re-print a receipt, and
clean the In-Feed conveyor.
•
••
• Service Mode - This mode starts once the technician logs into the RVM using
a USB drive and PIN. In this mode, the technician may complete in-depth
service and maintenance tasks on the RVM. Service Mode comprises three
components:
•
••
• Technician Interface
•
••
• Diagnostic Program
•
••
• Configuration Editor
4.2. Shop Mode
Figure 4-1 shows the Shop Mode screen. This mode allows store personnel and technicians to do the
following tasks without having to log in to Service Mode:
•
••
• Toggle Info Window - shows information about the RVM.
•
••
• Re-print Last Receipt - reprints the last customer receipt.
•
••
• Clear Error - clears errors shown on the RVM screen.
•
••
• Cleaning Mode - runs the conveyor belts to facilitate cleaning.