5050 CONTROL UNIT
Technical Manual & Cabling Instructions
19.10.2012
Epec Oy reserves all rights for improvements without prior notice
Epec Oy Postiosoite/Postal address Puhelin/Phone Fax Internet
Tiedekatu 6 PL/P.O.Box 194 +358-(0)20-7608 111 +358-(0)20-7608 110 www.epec.fi
FIN-60320 Seinäjoki FIN-60101 Seinäjoki, Finland
4.3.4 Software Channels for the Pulse Inputs
The possible software channels for the pulse inputs are listed in the following table according to
how many channel is needed and if there must be a possibility for a reset or not.
If there is no need for the reset functionality, reserve the pins from the bottom. This
way the pins with the reset possibility remains free for the possible future use.
Pin
Possible SW
Channels when 1
channel is
needed with no
reset
Possible SW
Channel pairs
when 2 chann
needed with no
reset
Possible SW Channels
when 1 channel is
needed with a reset
when 2-channel pulse
input is needed with a
reset
X2.06
1
pair 1
channel A channel A
X2.07
2
reset pin for the channel
channel B
X2.08
3
pair 2
channel A
reset pin for the channel
X2.09
4
reset pin for the channel
channel A
X2.15
5
pair 3
channel A channel B
X2.18
6
reset pin for the channel
reset pin for the channel
X3.07
7
pair 4
channel A channel A
X3.10
8
reset pin for the channel
channel B
X2.16
9
pair 5
channel A
reset pin for the channel
X2.17
10
reset pin for the channel
channel A
X2.19
11
pair 6
channel A channel B
X2.20
12
reset pin for the channel
reset pin for the channel
X3.08
13
pair 7
not supported not supported
X3.09
14 not supported not supported
X3.11
15
pair 8
not supported not supported
X3.12
16 not supported not supported
X3.05
17
pair 9
not supported not supported
X3.06
18 not supported not supported
X3.21
19
pair 10
not supported not supported
X3.22
20 not supported not supported
X3.23
21
pair 11
not supported not supported
X1.11
22 not supported not supported
To Next Page
Loading...
