EPS NEXUS Manual V1.5.2 EN WWW.EPSBV.EU 22
3.6. 2(Main unit) Product Providers.
Often pH and chlorine pumps are already connected, also the timer outputs can be connected via the terminal strip. If another output still
needs to be used, the instructions below can be used to connect other product providers.
Standard power supply: 230 V∼, 50 Hz, single-phase. Any other power supply is not allowed and will irreversibly damage the
system.
Before starting maintenance/repair/installation, ensure that the unit is de-energized and no fluids can leak.
Follow the legal guidelines on home electrical installations. Ensure that all components are properly installed hydraulically and
electrically before turning on the unit.
The system is equipped with a cable which must be connected in parallel with the filter pump. This is intended only as secondary protection
against injection without flow. Always connect and activate flow-through protection in the settings.
Dosing pumps or other product dispensers
To Next Page
Loading...