EPS NEXUS Manual V1.5.2 EN WWW.EPSBV.EU 35
• Configuration
Only for authorized technicians.
5.6.1 Manual mode (#11)
In manual mode, all actuators can be activated without any control/restriction. Caution! This menu is intended for authorized
personnel only. If you are incompetent or unsure about the operation, do not use this menu! The menu is protected with a PIN
code. The code can be found at the back of this manual.
Manual mode can be accessed through (11) 'general settings'. When entering the menu, all actuators that are currently controlled will be
switched off to be subsequently operated manually. The operation depends on the configured components.
Upon exiting the manual control menu, all actuators that are currently switched on will be switched off again to then be operated by the
automation.
5.7 filter control
The filter control contains everything related to the filter pump and sand filter (backwashing).
To Next Page
Loading...