EPS NEXUS Manual V1.5.2 EN WWW.EPSBV.EU 43
Water te heet
1. The "water temp. Protection" function can be enabled via the control panel. When the filter pump is switched on
because the water temperature exceeds 32 °C, the indication changes to "water too hot" and the filter pump is
switched on.
AUTOVALVE error
1. When the backwash configuration is set to AUTOVALVE, the system knows that an autovalve is connected. If the
autovalve does not (yet) indicate that it has reached the correct position, the filter pump is blocked and the indication
changes to off – autovalve error.
5.8 Setting up and operating backwind control
After the backwash installation is complete, the respective valve must be configured.
1. Swimming pool installations below water level should always be carried out with an electric sewer valve.
2. If possible, always install an electric sewer valve.
1. To do this, go to the filter control.
1. Choose 'backwash' and switch on the full control. The full backwash control can be switched on and off completely with
the button.
To Next Page
Loading...