EPS NEXUS Manual V1.5.2 EN WWW.EPSBV.EU 4
1 Introduction
1.1
Foreword
We are constantly working on developments, improvements and extensions and therefore reserve the right to make changes and
improvements to this manual and all products described in it without prior notice.
EPS B.V. is not responsible for the results of actions following the values shown on the display. Regardless of the cause and result of the
action, EPS B.V. is not responsible for the results obtained from using the product. It is the user's responsibility to check the values and
ensure correct operation of the device and third-party devices. Third-party devices controlled by the systems developed and produced by
EPS B.V. must always function correctly and EPS B.V. cannot be held liable for damage and/or consequential damage resulting from such
control.
Under warranty, EPS B.V. is only obliged to repair or replace products that comply with the warranty conditions. EPS B.V. will not be
responsible for any loss or wear and tear related to products, service, warranty or other aspects, including: financial losses, price paid for the
product, loss of income, loss of profits, loss of data, use of the product or related products, indirect or accidental damage, or any direct or
indirect damage related to the unavailability of the product, regardless of the duration of the unavailability.
1.2 Warnings, regulations safety
This manual is intended for technically qualified personnel responsible for the installation, settings and maintenance of the overall
system. The manufacturer is not responsible for damages and/or malfunctions following the intervention of unqualified personnel,
or by use contrary to this manual.
Never place the product near flammable products.
In case of leakage, always shut down the system immediately.
Before starting any maintenance and/or repair, ensure that the unit is de-energized and no fluids can leak.
In the event of a malfunction or anomaly (such as smoke or a burning smell coming from the product), turn off the power supply
and contact the installer.
Use only recommended spare parts. Use of non-recommended parts or modifications may damage the product and void the
warranty.
Warning! Always follow the warnings and general installation instructions!
Install the system away from heat sources, in a dry room protected from direct sunlight and a maximum ambient temperature of
40°C.
The minimum temperature should ensure that all "substances to be dosed" remain at least liquid and, in addition, not lower than
indicated in the "Technical Specifications" section.
The system should be installed on a vertical wall so that it hangs straight and firm. Choose a suitable location so that calibration,
operation and use are easily accessible.
Make sure that the device is connected to an outlet that is protected against short circuits. The device should also be powered
through an isolation transformer or a residual current device (RCD) with a rated operating fault current of no more than 30 mA.
Damage to cables or other components that cause a safety hazard should be replaced by authorized technicians.
Connect ground loops between the enclosure door and the enclosure itself and ensure that the entire enclosure grounding is
provided.
Always provide safety measures with pool covers within easy reach in case of emergency.
Before using a cover, always check for obstructions and proper operation as described in the manual of the unit itself. EPS B.V.
bears no responsibility for use of the slatted cover and any consequential damage.
Always record and maintain the chemical balance of the water in accordance with Department of Health recommendations.
Although monitoring systems are a great help in maintaining water quality, they are not a substitute for manual analysis.
Product: TOUCH SERIES
Type(s): All available since 01-01-2021
EMC: EN-IEC 55014-1 EN-IEC 55014-2
Safety: IEC 60335-1
To Next Page
Loading...