KEY SPEED TIME TO START Setting
0.1sec / 0.3sec / 0.5sec / 1.0sec / 1.5sec / 2.0sec / 2.5sec /
3.0sec
Specify the length of time until the cursor begins to move continuously
when a key is held down.
INTERVAL Setting
0.1sec / 0.3sec / 0.5sec / 1.0sec / 1.5sec / 2.0sec / 2.5sec /
3.0sec
Specify the length of time until the cursor continuously moves between
settings or characters.
LANGUAGE Setting
ENGLISH / FRENCH / GERMAN / ITALIAN / SPANISH /
PORTUGUESE / RUSSIAN / CZECH / SLOVAK /
HUNGARIAN / POLISH / TURKISH
Select the language of the menus and messages that appear in the message
window.
BUZZER VOLUME
(AcuLaser CX16NF only)
Setting
OFF / LOW / HIGH
Select the volume of the sound produced when a key is pressed and of the
alarm that is sounded when an error occurs.
INITIAL MODE
(AcuLaser CX16NF only)
Setting
COPY / FAX
Specify the default mode when the machine is turned on or when all settings
in the control panel return to their default settings.
TONER OUT STOP Setting
ON / OFF
Select whether or not printing, copying and faxing (for AcuLaser CX16NF)
stop when the toner has run out.
Printing, copying and faxing (for AcuLaser CX16NF) can continue, however,
the printing result are not guaranteed. If printing, copying and faxing are
continued, the message “TONER LIFE END /CHANGE X TONER” appears and
printing stops.
TONER LOW Setting
ON / OFF
Select whether or not a warning message appears when the toner is nearly
empty.
AUTO CONTINUE Setting
ON / OFF
Select whether or not printing continues when a size error occurs during
printing.
AcuLaser CX16 Series Printer / Copier / Scanner User’s Guide
Control Panel and Configuration Menu 33
To Next Page
Loading...
Need help?
General
