Note:
❏ If you do not load envelopes in the PSI right after they have been removed from the packaging, they
may bulge. To avoid jams, flatten them as shown below when loading them in the PSI.
❏ If envelopes are still not fed correctly, add some bending to the flap of the envelopes as shown in the
following illustration.
The amount of the bending shall be 5 mm (0.20 inches) or less.
❏ To confirm the correct orientation of each print media such as envelopes, see the instruction on the
Envelope/Paper Setup Navigator on the print driver.
Epson AcuLaser CX17 Series User’s Guide
Printing Basics 131
To Next Page
Loading...
