Epson AcuLaser CX17 Series User Manual

12. Press the button.
The next three digits are highlighted.
13. Repeat steps 11 to 12 to enter all of the digits in the IP address, and then press the
button.
14. Press the
(Back) button, and then ensure that IP Address is selected.
15. Select Subnet Mask, and then press the
button.
The cursor is located at the first three digits of the subnet mask.
16. Enter the value of the subnet mask using the numeric keypad.
17. Press the
button.
The next three digits are highlighted.
18. Repeat steps 16 to 17 to set subnet mask, and then press the
button.
19. Press the
(Back) button, and then ensure that Subnet Mask is selected.
20. Select Gateway Address, and then press the
button.
The cursor is located at the first three digits of the gateway address.
21. Enter the value of the gateway address using the numeric keypad.
22. Press the
button.
The next three digits are highlighted.
23. Repeat steps 21 to 22 to set gateway address, and then press the
button.
24. Turn off and turn on the printer.
See Also:
“Operator Panel” on page 30
The Printer Setting Utility
The following procedure uses Windows XP as an example.
Epson AcuLaser CX17 Series User’s Guide
Printer Connection and Software Installation 49

Epson AcuLaser CX17 Series Specifications

General

Brand	Epson
Model	AcuLaser CX17 Series
Category	Printer
Language	English