The “Configuration Complete” screen appears.
13. Wait a few minutes until the printer restarts to establish the wireless network.
14. Click Next.
15. Follow the on-screen instructions until the “Check Setup” screen appears.
16. Print a System Settings page from the operator panel.
See “Printing a System Settings Page” on page 149.
17. Confirm that “Link Quality” is shown as “Good”, “Acceptable” or “Low” on the report.
Note:
When “Link Quality” is “No Reception”, check if the wireless settings are correctly configured. To
reconfigure the wireless settings, click Return.
18. Confirm there are no errors displayed on the LCD panel, and then click Start Installation.
Epson AcuLaser CX17 Series User’s Guide
Printer Connection and Software Installation 74
To Next Page
Loading...
