Epson DS-1660W - Web Config; Options Information; Network Interface Unit Codes

Web Cong
Web Cong is an application that runs in web browsers, such as Microso Edge and Safari, on devices such as a
computer or a smart device. You can
congure
network services and change scanner settings. To use Web
Cong
,
connect your device to the same network as the scanner.
Note:
You may be prompted to enter the administrator password while using this device. See the following for details on the
administrator password.
“Notes on the Administrator Password” on page 10
To access Web Cong, enter the scanner’s IP address in your web browser. You can check the IP address in Epson
Scan 2.
oFormat:
IPv4: http://scanner’s IP address/
IPv6: http://[scanner’s IP address]/
oExample:
IPv4: http://192.168.100.201/
IPv6: http://[2001:db8::1000:1]/
Note:
o An administrator password may have been set by default depending on the time and region of purchase.
Even if you have not set an administrator password
aer
purchasing the device, but you are prompted to enter it, this
indicates that the administrator password is set by default.
In this situation, the value is the 8-digit number on the "PASSWORD" label attached to the back of the product.
o You can also start Web Cong from EpsonNet Cong or the WSD port.
Related Information
& “Notes on the Administrator Password” on page 10
Options Information
Network Interface Unit Codes
You can scan through a network by using Document Capture Pro (Windows only). By registering frequently used
scan process settings such as save, sort, transfer, and so on, with a name such as "job", you can reduce the workload
and increase
eciency
by simply selecting “job” on the control panel. See the manual for more details.
User's Guide
Scanner Basics
17