Epson DS-1660W - Checking the Network Status Using Network Light; Replacing or Adding New Access Points; Changing the Connection Method to a Computer

1.
Press the
button on the scanner’s control panel.
e
light is lit blue when AP mode connection is enabled.
2. Connect from the smart device or computer to the scanner using the scanner’s SSID and password.
Note:
o You can check the SSID and password on the label stuck to the scanner.
o See the documentation provided with your smart device or computer for the operating instructions.
Related Information
& “Basic Scanning” on page 29
& “Advanced Scanning” on page 39
& “Network Problems” on page 78
Checking the Network Status Using Network Light
You can check the network connection status using the network light on the scanner’s control panel.
Related Information
&
“Error Indicators” on page 15
Replacing or Adding New Access Points
If the SSID changes due to the replacement of an access point, or an access point is added and a new network
environment is established, re-set the Wi-Fi settings.
Related Information
& “Changing the Connection Method to a Computer” on page 60
Changing the Connection Method to a Computer
Using the installer and re-set up in a dierent connection method.
o Setting up from the website
Access the following website, and then enter the product name.
http://epson.sn
Go to Setup, and then click Download in the download and connect part. Click or double-click the
downloaded le to run the installer. Follow the on-screen instructions.
o Setting up using the soware disc (only for the models that come with a soware disc and users with computers
with disc drives.)
Insert the
soware
disc into the computer, and then follow the on-screen instructions.
User's Guide
Network Settings
60