Epson DS-1660W - Connecting to a Smart Device; Making Wi-Fi Settings from the Control Panel; Making Wi-Fi Settings by Push Button Setup (WPS)

Connecting to a Smart Device
You can use the scanner from a smart device when you connect the scanner to the same Wi-Fi network (SSID) as
the smart device. To use the scanner from a smart device, set up from Epson DocumentScan.
Note:
o If you want to connect a computer and a smart device to the scanner at the same time, we recommend connecting the
computer rst.
o You can install Epson DocumentScan from App Store or Google Play.
Making Wi-Fi Settings from the Control Panel
You can make network settings from the scanner's control panel. Aer connecting the scanner to the network,
connect to the scanner from the device that you want to use (computer, smart phone, tablet, and so on.)
Making Wi-Fi Settings by Push Button Setup (WPS)
You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
o e access point is compatible with WPS (Wi-Fi Protected Setup).
o
e
current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot nd the button or you are setting up using the soware, see the documentation provided with the access point.
1. Hold down the [WPS] button on the access point until the security light ashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
2.
Press the
button on the scanner’s control panel until the light
ashes
blue (approximately 3 seconds).
e connection setting starts. e
light and light ash alternately.
e
light is lit blue when connection is complete.
User's Guide
Network Settings
58