Epson DS-1660W - Making Wi-Fi Settings by PIN Code Setup (WPS); Making AP Mode Settings

Note:
Connection fails when the
light turns on.
Aer
releasing the error by pressing the button, restart the access point,
move it closer to the scanner, and then try again.
Related Information
& “Basic Scanning” on page 29
& “Advanced Scanning” on page 39
& “Network Problems” on page 78
Making Wi-Fi Settings by PIN Code Setup (WPS)
You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Press the
button and the button on the scanner’s control panel simultaneously until light
ashes
in blue (approximately 3 seconds).
2. Use your computer to enter the PIN code (an eight-digit number) on the label stuck to the scanner into the
access point within two minutes.
e connection setting starts. e
light and light ash alternately.
e
is lit blue when connection is complete.
Note:
o See the manual provided with your access point for details on entering a PIN code.
o Connection fails when the
light turns on. Aer releasing the error by pressing the button, restart the access
point, move it closer to the scanner, and then try again.
Related Information
& “Basic Scanning” on page 29
& “Advanced Scanning” on page 39
& “Network Problems” on page 78
Making AP Mode Settings
is method allows you to connect the scanner directly to devices without an access point. e scanner acts as an
access point.
c
Important:
When you connect from a smart device to the scanner using the AP mode connection, the scanner is connected to
the same Wi-Fi network (SSID) as the smart device and communication is established between them. Since the
smart device is automatically connected to other connectable Wi-Fi networks if the scanner is turned o, it is not
connected to the previous Wi-Fi network again if the scanner is turned on. Connect to the scanner’s SSID in AP
mode from the smart device again. If you do not want to connect every time you turn the scanner on or o, we
recommend using a Wi-Fi network by connecting the scanner to an access point.
User's Guide
Network Settings
59