22
Before Connecting
Usually, when a computer is connected to a network system by using
an access point or wired LAN, you do not need to change the network
settings on the computer. Install EMP NS Connection in EasyMP
Software on the computer.
Set the network on the projector.
As well as projecting images from a computer via a network, you can
also monitor the status of the projector by connecting using these
methods.
f Preparing the computer
s p.23
Carry out the following procedures in advance.
• Put the computer into network connection status
• Install the EasyMP Software
f Preparing the projector
s p.24
• Projector network settings
To Next Page
Loading...
Need help?
General
