36
When the Projector you want to Connect to is not Displayed
For reasons such as the following, there are times when the projector
you want is not displayed in the EMP NS Connection’s select a
projector screen.
• The electromagnetic waves for the wireless LAN are out of range or
weak.
• The network’s subnet is different.
In this case you can search by using "Manual Search" or "Profile".
You can search by specifying the projector’s IP address or the
projector’s name when using "Manual search" in "Advanced
Connection Mode".
Also, information for the projector that is frequently used (such as the
IP address) is saved as a profile and you can search for the projector
by specifying the information. s p.40
In the following explanations, unless otherwise noted, Windows screen
shots are used.
You see a similar screen even when using Macintosh.
Searching by Specifying the IP Address and
Projector Name (For Advanced Connection Mode)
A
Click "Manual search" on the EMP NS Connection’s
select a projector screen.
q
• When you use "Manual search" in "Quick Connection
Mode", you can specify the ESSID. When there are a lot
of projectors you can narrow the search field by using
ESSID.
• It is also possible that "AirPort: Not inserted" or "An
appropriate access point has not been selected" are
reasons that the target projector is not displayed.
Procedure
To Next Page
Loading...
Need help?
General
