Network Settings Function List
30
SNMP Menu
You can set the SNMP. To use SNMP to monitor the projector, you need
to install the SNMP manager program on your computer. SNMP should
be managed by a network administrator.
Setup Complete Menu
It returns to the configuration menu.
SNMP trap IP
address 1/ SNMP
trap IP address 2
You can register up to two for the SNMP trap
notification destination.
The IP address registered in "Trap IP Address 2" is
used when the IP address in "Trap IP Address 1"
cannot be accessed.
You can enter a number from 0 to 255 in each field of
the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number from 0 to 255)
To Next Page
Loading...
