Network Settings Function List
29
Mail Menu
When this is set, if the projector enters an abnormal/warning state, you are
notified by e-mail.
Mail Notification
Settings
You can set whether to be notified by mail (On) or not
(Off).
IP address of SMTP
server
You can enter the IP address for the SMTP server for
the projector.*
You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses
cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number from 0 to 255)
Port Number You can enter the SMTP server’s port number. The
initial value is 25. You can enter a numeric value from
1 to 65535.
Destination address
1/Destination
address 2/
Destination address
3
You can enter the mail address and the contents of the
message to receive notification when an abnormality or
warning occurs. You can register up to three addresses.
You can enter up to 32 single-byte alphanumeric
characters for the mail address.
Setting a Notification
Event
You can select the abnormalities or warnings to be
notified about by mail. When the selected abnormality
or warning occurs in the projector, a mail is sent to the
specified "Destination address" notifying that an
abnormality or warning has occurred. You can select
multiple items from the displayed items.
To Next Page
Loading...
Need help?
General
