Network Settings Function List
26
Wireless LAN Menu
Security Menu
Connection mode You can specify either "Quick Connection Mode" or
"Advanced Connection Mode" as the connection mode.
Antenna level Displays the electromagnetic wave strength of the
wireless LAN.
Wireless LAN
system
You can specify either "802.11g/b" or "802.11a" as the
wireless LAN method.
ESSID Enter an ESSID. When an ESSID is provided for the
wireless LAN system in which the projector
participates, enter the ESSID. The initial value is
EPSON.
You can enter up to 32 single-byte alphanumeric
characters.
DHCP You can set whether to use DHCP (On) or not (Off).
IP address You can input the IP address assigned to the projector.*
You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.
255.255 (where x is a number from 0 to 255)
Subnet mask You can enter the subnet mask for the projector.*
You
can enter a number from 0 to 255 in each field of the
address. However, the following subnet mask cannot be
used.
0.0.0.0, 255.255.255.255
Gateway address You can enter the gateway IP address for the
projector.*
You can enter a number from 0 to 255 in each field of
the address. However, the following gateway address
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.
255.255 (where x is a number from 0 to 255)
Security You can select the type of security you want. The
setting items vary depending on the type you select.
To Next Page
Loading...
Need help?
General
