80
Sending Scenarios
To project a created scenario using the projector, send the scenario to
a USB storage device using "Send Scenario" in EMP SlideMaker2.
Specify a USB hard disk drive or a USB storage device that is
connected to the computer’s USB port as the destination.
It is also possible to set automatic projection and continuous projection
of a scenario at projector startup. The automatic projection function is
called "autorun".
A
Once the scenario is completed, connect a USB
storage device to the computer
and then select "Scenario Options" - "Send
Scenario".
B
A dialog box for designating the destination drive is
displayed. Select the drive and the folder where the
USB storage is connected and click the "OK"
button.
C
When a confirmation message is displayed, click
the "OK" button.
It is sent to the scenario destination selected.
q
• When "Send Scenario" is performed, the scenario file is
saved in the destination under the name "Scenario
name.sit". Also, a folder with the same name as the
scenario is created and each screen is converted to image
files and saved according to image quality. However, in PC
Free a folder with the same name as the scenario is not
displayed.
• If you use "Send Scenario" without saving, a folder with
the same name as the scenario name and a "scenario
name.sit" file are created in the scenario folder. Each
screen is converted to image files and saved in the created
folder according to the image quality.
Procedure
To Next Page
Loading...
Need help?
General
