Troubleshooting
95
f Error message when starting up EMP Monitor
Check Remedy
The password is incorrect. The wrong password was entered. Enter the correct password. If you forget the password, start "Network
Settings" in "Network" from the configuration menu, and check "WEB Control Password" in "Basic
Settings".
Cannot connect to the projector for the IP address
that was entered.
Check whether the network settings for the projector you want to connect to, the wired LAN or Advanced
Connection Mode (wireless LAN) are the settings that are used.
When "Quick Connection Mode" is selected from "Wireless LAN", the setting is changed to "Advanced
Connection Mode".
Next, check the "IP Address" for the "Wired LAN" or the "Wireless LAN" and register the "IP Address"
manually. sEMP Monitor Operation Guide
If it still does not connect, check the network settings on the computer and the network settings for the
projector.
For network settings, see s"Projector Network Settings"
To Next Page
Loading...
Need help?
General
