You can schedule turning the projector power on/off and switching the
input source, as events in the schedule. Registered events are executed
automatically at the specified time on the specified dates or weekly.
You can register up to 30 events in Schedule, and one event in Extended
Schedule.
Saving an Event
Setting an Event
a
Press the [Menu] button while projecting.
s
"Configuration Menu Operations" p.136
b
Select Schedule Settings from Extended.
c
Select Add New from Schedule.
d
Set the schedule.
Submenu Name Function
Event Settings
Select an operation of the projector when the event
is executed. Select No Change for items that you do
not want to change when the event occurs.
You can set the following item operations.
Schedule
• Power
• Source
• Light Source Mode
• A/V Mute
• Light Source Calibration
• Refresh Mode
• Volume
Date / Time Settings
Set the date, day of the week, and time to execute
the event. You can set up to four weeks later. Use
the soft keyboard to enter the date and time.
s "Soft keyboard operations" p.152
e
Select Save, and then press the [ ] button.
To register additional events, repeat steps 3 to 5.
f
Select Setup complete, and then select Yes to finish saving.
a
• Light Source Calibration does not start automatically when the
projector is used continuously for more than 24 hours, or when
direct shutdown is used regularly. Set Light Source Calibration to
enable this function after every 100 hours of usage.
• When Light Source Calibration is enabled, turn on the projector at
least 20 minutes before the event.
Scheduling Function
112
To Next Page
Loading...
