Image colors are not right
Check Remedy
Do the input signal settings match the signals from the connected
device?
Change the setting according to the signal for the connected equipment.
s Signal - Advanced - Input Signal p.142
Is the image brightness adjusted correctly? Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.140
Are the cables connected correctly? Check that all the cables required for projection are securely connected.
Check that no cables are disconnected and that there are no poor contacts in the cables.
s "Connecting Equipment" p.47
Is the Contrast adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.140
Is the color adjustment set correctly? Adjust the Gamma or RGBCMY setting from the Configuration menu.
s Image - Advanced p.140
s "Adjusting the Image" p.81
Are the color saturation and tint adjusted correctly? Adjust the Color Saturation and Tint settings from the Configuration menu.
s Image - Color Saturation, Tint p.140
Are you projecting from multiple projectors at the same time? Make sure that Light Source Calibration from the Reset menu is set correctly for all of the projectors. If Light Source
Calibration is only executed for some of the projectors, there may be differences in the White Balance or the Brightness
Level between projectors.
If there are still differences in the color, set Light Source Calibration to Off.
Images appear dark
Check Remedy
Is the image brightness set correctly? Check the Brightness and Brightness Settings values from the Configuration menu.
s Image - Brightness p.140
s Settings - Brightness Settings p.143
Is the Contrast adjusted correctly? Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.140
Problem Solving
195
To Next Page
Loading...
