f
Secure the lever with the lever lock to make sure it does not come
loose.
a
The lever is secured even without using the lever lock, but this
adds an additional measure of safety.
g
Attach the lens replacement cover.
a
When projecting down, we recommend securing the front cover
with commercially available screws (M3 x 8 mm).
Lens Calibration
After replacing the lens unit, calibrate the lens so that the projector can
correctly acquire the lens position and adjustment range.
After attaching a different lens unit from the previous one, a message is
displayed when the projector is turned on.
Select Yes to calibrate the lens.
Lens calibration takes up to about 100 seconds until it is complete. When it
is complete, the lens position returns to the position before calibration
(ELPLX01/ELPLX01W returns to the standard position).
Installing the Projector
29
To Next Page
Loading...
