Adjusting the Horizontal Tilt (for Normal
Installment)
Extend and retract the front and rear feet to adjust the projector's
horizontal tilt. You can adjust the tilt within a range of ±1.5˚.
A
Extend the front and rear feet.
B
Retract the front and rear feet.
Attention
The rear feet are detachable. You can extend the feet by approximately 12
mm before they detach.
ID Settings
When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is very useful when managing multiple projectors. You can set up to 30
IDs.
a
• Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Remote control operating range" p.24
• IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
• If you use Epson Web Control, you can operate a specific projector
from a mobile device.
s "Changing Settings Using a Web Browser (Epson Web Control)"
p.215
Set the projector ID
a
Press the [Menu] button while projecting.
s "Configuration Menu Operations" p.136
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [ ] button.
d
Press the [ ][ ] buttons to select an ID number.
Installing the Projector
42
To Next Page
Loading...
